Installing a New Program - AccuStream AS-Series PLC (XLt)

Written By: Ryan Engelhardt (and 2 other contributors)
  • Comments: 5
  • Favorites: 0
  • Completions: 2

Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

1

Flags

0

  1. Remove microSD card from PLC by pushing down on card. Remove microSD card from PLC by pushing down on card.

    • Remove microSD card from PLC by pushing down on card.

  2. Insert microSD card into included card reader. Insert card reader, with microSD card installed, into computer's USB drive. Make sure card reader is inserted as shown in picture #2 of this section.

    • Insert microSD card into included card reader.

    • Insert card reader, with microSD card installed, into computer's USB drive.

    • Make sure card reader is inserted as shown in picture #2 of this section.

    • Copy new program from computer to microSD card.

  3. After program has been copied to microSD card, remove card from computer.

    • After program has been copied to microSD card, remove card from computer.

    • Insert microSD card into PLC.

  4. Starting at main screen, press Menu. Press Config and enter password to enter configuration screen. Press Config and enter password to enter configuration screen.

    • Starting at main screen, press Menu.

    • Press Config and enter password to enter configuration screen.

  5. On configuration screen, press Load Program. Press Load Application on center of screen.

    • On configuration screen, press Load Program.

    • Press Load Application on center of screen.

  6. Press up or down arrow to highlight program to be loaded (.PGM file extension). Press enter at bottom right of screen.

    • Press up or down arrow to highlight program to be loaded (.PGM file extension).

    • Press enter at bottom right of screen.

  7. Once prompted, press OK to load new program. Enter password for new program (AccuStream supplied) and press Enter. Enter password for new program (AccuStream supplied) and press Enter.

    • Once prompted, press OK to load new program.

    • Enter password for new program (AccuStream supplied) and press Enter.

  8. After program has loaded, press OK to place pump in run mode.

    • After program has loaded, press OK to place pump in run mode.

    • Pump is now ready to operate with new program.

Finish Line

2 other people completed this guide.

Author

with 2 other contributors

Ryan Engelhardt

Member since: 06/26/2012

4 Guides authored

5 Comments

ok I will try

Artur - Reply

that's the problem here because the local service doesn't know me to help me

Artur - Reply

Are you able to email or call the Hypertherm technical service team in Europe? They should be able to assist even if they don't know you.

Arion Vandergon -

and where can you download the PGM file ??

Artur - Reply

Please contact your local technical service team and they will help get the PGM file for you.

Arion Vandergon -

Add Comment