Changes to Step #14

Edit by Adam Dumas —

Edit approved by Adam Dumas

Before
After
Unchanged

Step Lines

-[* black] Slide bushing onto point of needle with chamfered end towards back-up screw
-[* black] Place hoop onto HP Seal with tapered end towards seal and opposite from o-ring
-[* black] Place HP seal assembly onto point of needle with hoop first
+[* black] Slide the bushing onto the point of the needle with the chamfered end towards the back-up screw.
+[* black] Place the hoop onto the high-pressure seal with the tapered end towards the high-pressure seal and opposite from the O-ring.
+[* black] Place the high-pressure seal assembly onto the point of the needle with the hoop, first.