Skip to main content

Changes to Step #2

Edit by Adam Dumas

Edit approved by Adam Dumas

Before
After
Unchanged

Step Lines

-[* black] Inspect inside of HP cylinder, if scratches/galling have occurred, use scotch brite or similar abrasive pad in each end to remove blemishes
-[* black] Repeat process (if needed) with 1500 abrasive to polish inside bore
-[* black] Apply HP Lubricant to red o-ring
+[* black] Slide o-ring on to HP seal
+[* black] Insert HP Seal level to HP cylinder
+[* black] Insert static back-up behind the HP seal with static back-up level with face of HP cylinder

Image 1

Old Version

New Version

Image 2

Old Version

New Version

Image 3

Old Version

New Version