Skip to main content
/

Site Navigation

Your Account

Choose Language

Changes to Step #2

Edit by Adam Dumas

Edit approved by Adam Dumas

Before
After
Unchanged

Step Lines

-[* black] Inspect inside of HP cylinder, if scratches/galling have occurred, take 180 grit abrasive to each end to remove blemishes
-[* black] Repeat process with scotch brite to polish inside of bore
-[* black] Lubricate red o-ring with HP Lubricant
+[* black] Inspect inside of HP cylinder, if scratches/galling have occurred, use Scotch Brite or similar abrasive pad to each end of HP cylinder to remove blemishes
+[* black] Repeat process (if needed) with 1500 grit abrasive to polish inside of bore
+[* black] Lubricate o-ring with HP Lubricant