Skip to main content

Changes to Step #4

Edit by Arion Vandergon

Edit approved by Arion Vandergon

Before
After
Unchanged

Step Lines

-[* black] Insert wisdom here.
+[* black] Insert 5/16-18 X 1 inch bolts (4) with flat washers (4) through the motor plate and mounting plate. Hand thread 5-16-18 Nyloc hex nuts (4) with flat washers (4) onto the bolts.
+[* black] Use two 1/2 standard open end, box end, or combination end wrenches to tighten the nuts (4) on the bolts (4)
+[* black] Check and verify that the motor is secured to the mounting bracket and frame. Also check to ensure that no water lines are contacting/rubbing any hydraulic lines.
+[* black] Continue normal pump operation.